Powder and wet coating

RMIG offers to arrange powder coating as well as wet coating.

Powder coating:
The advantages of powder coating are:  

• A thick layer can be applied in one process (50-300 micron).  
• The finished result gives a more uniform surface.  
• Powder coating is less affected by mechanical wear and therefore easier to clean.  
• Simple packing can be used because of the strength of the coating.   
• Long outdoor life with the right preliminary treatment.   
• Large choice of colours.  
• Materials with holes down to and including 1.0 mm diameter can be powder coated. (If the holes are smaller than 1.0 mm the possibility must be investigated in each case.)  
• Suitable for mass production.  
• Basically a cheaper process than for instance wet coating.  

• A very elegant appearance / finish can be achieved.  
• Wet coating is very suited for materials to appear multi-coloured.  
• Very long outdoor life if the layer thicknesses are right.  
• Large choice of colours.  
• Materials with holes down to and including 1.0 mm diameter can be wet coated. (If the holes are smaller than 1.0 mm the possibility must be investigated in each case.)